P0470
Exhaust Pressure Sensor A Circuit
The exhaust pressure sensor measures the pressure ahead of the turbine or in the manifold (Ford: turbine upstream pressure, Cummins: exhaust manifold pressure, older Ford diesels: EBP). The module uses it to calculate EGR flow, to control the variable turbine and engine braking, and to protect against overpressure. P0470 is the general circuit fault of sensor A. Ford's 6.7-litre diesel with a digital SENT sensor sets it when the sensor reports an error status or its raw data leave their limits for 5 s; a loss of communication is U0691 instead. Analogue sensors use it for an open or unspecified circuit fault where low and high are not separated.
Possible causes
- Sensor faulty internally high
- Connector corroded or heat-damaged near the manifold medium
- Broken or chafed signal or 5 V wire medium
- Engine module or software low
Symptoms
- Check engine light on
- EGR and turbo control on a substitute value, possibly reduced power
- Exhaust brake or warm-up flap without function
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P0470
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.