P046D
EGR Sensor A Circuit Intermittent/Erratic
Exhaust gas recirculation (EGR) routes part of the exhaust back into the intake to lower combustion temperature and NOx. Which part EGR sensors A and B are depends on the maker: sensor A is usually the position sensor of EGR valve A; GM's Duramax diesels of 2017/18 use sensor B for the coolant temperature sensor at the inlet of the high-pressure EGR cooler, FCA for the position sensor of the low-pressure valve. P046D means brief excursions of sensor A out of its valid range, too short for P0405/P0406. Ford petrol engines from 2020 set it when the position signal stays above 95 % or below 5 % of its range for just 0.4 s, whereas 4 s set P0405/P0406; the check runs continuously during the EGR monitor above 8.25 V and 400 rpm. EGR is then switched off.
Possible causes
- Loose contact or corrosion at the EGR valve connector high
- Chafed wire with brief short to ground or positive medium
- Position sensor in the valve worn medium
- Disturbed 5 V reference low
Symptoms
- Check engine light on, may come and go
- Usually no noticeable change
- Occasional jerking when EGR switches off
Inspection / repair
- Difficulty: easy
- DIY: possible
What Pro shows you for P046D
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 4 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.