OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P046C

EGR Sensor A Circuit Range/Performance

Exhaust gas recirculation (EGR) routes part of the exhaust back into the intake to lower combustion temperature and NOx. Which part EGR sensors A and B are depends on the maker: sensor A is usually the position sensor of EGR valve A; GM's Duramax diesels of 2017/18 use sensor B for the coolant temperature sensor at the inlet of the high-pressure EGR cooler, FCA for the position sensor of the low-pressure valve. P046C means the signal of sensor A is electrically valid but implausible. GM's diesels (6.6-litre Duramax LML and others from 2014) set it when the actual valve position deviates from the target by 5 % or more for 8 s, with offset learning completed and at least 11 V (MIL after two trips). Ford uses P0405/P0406/P046D for sensor A instead. EGR is then switched off or limited.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number4 / 6C

Possible causes

  • EGR valve coked and stiff, actual position does not follow high
  • Position sensor worn or offset shifted medium
  • Contact resistance at connector or 5 V supply medium
  • Values not relearned after valve replacement low

Symptoms

  • Check engine light on
  • EGR switched off, possibly higher NOx
  • Rarely jerking or lack of power

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P046C

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication