P0467
EVAP Purge Flow Sensor Circuit Low
The evaporative emission (EVAP) system stores fuel vapour from the tank in a charcoal canister; a purge valve lets the engine draw it off, and a vent valve opens the canister to fresh air. A purge flow sensor – a heated thermistor in the purge line between purge valve and intake manifold, as described in a Ford patent – measures purge flow directly for the CARB purge monitor. Today indirect methods (fuel trim, tank vacuum) have largely replaced it; no manufacturer document available to us uses these codes. P0467 means the signal voltage is below its lower limit – signal shorted to ground, supply missing or sensor faulty. The purge flow monitor can then not be evaluated.
Possible causes
- Signal wire shorted to ground high
- Sensor faulty medium
- Supply or reference open medium
Symptoms
- Check engine light on
- EVAP readiness not set, emission inspection not passed
- No change in driving
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P0467
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 4 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.