P0465
EVAP Purge Flow Sensor Circuit
The evaporative emission (EVAP) system stores fuel vapour from the tank in a charcoal canister; a purge valve lets the engine draw it off, and a vent valve opens the canister to fresh air. A purge flow sensor – a heated thermistor in the purge line between purge valve and intake manifold, as described in a Ford patent – measures purge flow directly for the CARB purge monitor. Today indirect methods (fuel trim, tank vacuum) have largely replaced it; no manufacturer document available to us uses these codes. P0465 is the general circuit fault of the sensor (heater supply, signal or ground), which CARB requires to be checked continuously. The purge flow monitor can then not be evaluated.
Possible causes
- Connector or wire at the purge flow sensor high
- Sensor (heater or thermistor) faulty medium
- Engine module low
Symptoms
- Check engine light on
- EVAP readiness not set, emission inspection not passed
- No change in driving
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P0465
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 4 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.