P0464
Fuel Level Sensor A Circuit Intermittent
The fuel level sensor is a float on a resistor track in the tank unit. It is no emission part, but other monitors depend on it – the EVAP leak tests, for example, need at least 15 % fuel – so CARB requires it to be monitored and the usual exemption from the warning lamp does not apply. At GM, P0464 is a by-product of the engine-off EVAP leak test: a jump in fuel level with the vent valve closed counts as possible refuelling and aborts the test; if a following check finds no real refuelling, the jump is counted as an intermittent sensor signal (change above 10 % not stable for 30 s, 2 of 3 samples). GM sets the code with MIL on the first trip, because otherwise the leak monitor would be defeated permanently. Ford does not use P0464 and reports jumps as P0461.
Possible causes
- Loose contact or corrosion at the tank connector or sensor terminal high
- Worn spots on the resistor track (wiper skipping) high
- Chafed wire with intermittent contact medium
- Car parked on a steep slope or fuel sloshing after switch-off low
Symptoms
- Check engine light on (GM after one trip)
- Fuel gauge occasionally jumps
- EVAP readiness not set
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P0464
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 4 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.