OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0462

Fuel Level Sensor A Circuit Low

The fuel level sensor is a float on a resistor track in the tank unit. It is no emission part, but other monitors depend on it – the EVAP leak tests, for example, need at least 15 % fuel – so CARB requires it to be monitored and the usual exemption from the warning lamp does not apply. Low and high refer to the signal, not the fuel level: on GM a full tank is about 40 Ω and a low voltage, while Ford judges the resistance directly. P0462 means the signal is below its lower limit: GM below 10 % of the 5 V reference (100 of 125 samples, MIL after two trips), Saab 9-4X below 0.25 V for 5 s, Ford a resistance below 5 Ω for 30 s. Typical is a signal wire shorted to ground or a shorted sensor. The gauge sticks at one end and a substitute value is used.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number4 / 62

Possible causes

  • Signal wire shorted to ground (chafed at tank or underbody) high
  • Sensor shorted or damaged internally medium
  • Water or corrosion in the tank connector medium
  • Evaluating module faulty low

Symptoms

  • Fuel gauge wrong, stuck or jumping
  • Range display and low-fuel warning wrong
  • Check engine light (depending on the maker)

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P0462

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication