OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0460

Fuel Level Sensor A Circuit

The fuel level sensor is a float on a resistor track in the tank unit. It is no emission part, but other monitors depend on it – the EVAP leak tests, for example, need at least 15 % fuel – so CARB requires it to be monitored and the usual exemption from the warning lamp does not apply. P0460 is the general circuit code for sensor A, the main or only fuel level sensor. Ford sets it instead of P0462/P0463 below 5 Ω or above 200 Ω for 30 s and until about 2012 also used it for a stuck sensor (fuel use compared over 100–120 miles); Saab's Trionic T8 uses it for a sensor that does not change. GM does not use P0460. The gauge then shows wrong values or a substitute, and level-dependent monitors do not run.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number4 / 60

Possible causes

  • Resistor track worn or float arm sticking high
  • Wire or connector at the tank unit open or shorted (corrosion) medium
  • Instrument cluster or gateway sends a wrong value (if the level comes via the bus) low
  • Frequent topping up or overfilling (plausibility test fails without a defect) low

Symptoms

  • Fuel gauge wrong, stuck or jumping
  • Range display and low-fuel warning wrong
  • Check engine light (depending on the maker)

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P0460

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication