OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P045F

EGR B Control Stuck Closed

Exhaust gas recirculation (EGR) routes part of the exhaust back into the intake to lower combustion temperature and NOx. EGR B is a second EGR valve next to valve A – on diesels with two EGR circuits the low-pressure valve, which takes exhaust after the particulate filter and feeds it in before the turbo compressor. GM's diesels of 2016–18 and FCA's 2.2-litre diesel in the Jeep Wrangler use it. P045F means valve B does not open: its actual position stays below the target despite the open command. GM lists the code among those that switch off low-pressure EGR control; Ford's comparable valve A check (P042F) compares the position with a calculated lower limit. Too little EGR raises NOx while driving stays normal. Icing or condensate can block a low-pressure valve – FCA runs its cleaning routine only above 0 °C.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number4 / 5F

Possible causes

  • Low-pressure valve coked or stuck high
  • Actuator motor or gear faulty medium
  • Icing or condensate in the low-pressure circuit low
  • Position sensor reports a wrong position low

Symptoms

  • Check engine light on
  • Low-pressure EGR switched off, possibly higher NOx
  • Usually no change in driving

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P045F

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication