P045A
EGR B Control Circuit
Exhaust gas recirculation (EGR) routes part of the exhaust back into the intake to lower combustion temperature and NOx. EGR B is a second EGR valve next to valve A – on diesels with two EGR circuits the low-pressure valve, which takes exhaust after the particulate filter and feeds it in before the turbo compressor. GM's diesels of 2016–18 and FCA's 2.2-litre diesel in the Jeep Wrangler use it. P045A is the general electrical fault in the drive circuit of valve B, typically an open circuit (for valve A GM uses 200 kΩ or more). GM lists this code among those that switch off the low-pressure EGR position control, but publishes no thresholds for it; the description follows the comparable valve A checks and CARB, which requires output circuits to be monitored. Low-pressure EGR is then switched off.
Possible causes
- Connector at EGR valve B corroded or loose high
- Harness chafed or heat-damaged medium
- Actuator motor in valve B open medium
- Driver in the engine module low
Symptoms
- Check engine light on
- Low-pressure EGR switched off, possibly higher NOx
- Usually no change in driving
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P045A
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 4 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.