P0459
EVAP System Purge Control Valve A Circuit High
The evaporative emission (EVAP) system stores fuel vapour from the tank in a charcoal canister; a purge valve lets the engine draw it off, and a vent valve opens the canister to fresh air. Purge valve A is switched to ground by the module and fed from the main relay. P0459 means its control wire is shorted to positive, detected with the driver switched on, when the line should sit at ground (GM 20 of 25 samples, MIL after two trips; Saab ME9 above 4.6 V). The valve then cannot open, the canister is not purged and fills up; the driver protects itself and the leak tests are suspended.
Possible causes
- Control wire shorted to battery voltage or supply high
- Purge valve coil low-resistance (shorted turns) medium
- Connector or harness damaged medium
- Engine module low
Symptoms
- Check engine light on
- Fuel smell when the canister is full
- EVAP readiness not set
Inspection / repair
- Difficulty: easy
- DIY: possible
What Pro shows you for P0459
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.