OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0453

EVAP System Pressure Sensor/Switch A Circuit High

The evaporative emission (EVAP) system stores fuel vapour from the tank in a charcoal canister; a purge valve lets the engine draw it off, and a vent valve opens the canister to fresh air. The tank pressure sensor measures small pressures around ambient for the leak tests. Its direction differs by maker – on GM vacuum raises the voltage, on Ford and Bosch pressure does – so low and high refer to the signal voltage only. P0453 means its signal voltage is above the upper limit: GM above 4.85 V (640 of 800 samples, MIL after two trips), Ford and Saab 9-4X above 4.9 V for 5 s. Ford states explicitly that an open circuit sets P0453, because the module's pull-up then drives the signal high. Other causes are a short to 5 V or battery voltage. Leak tests are then suspended.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number4 / 53

Possible causes

  • Signal or ground wire open, connector off high
  • Tank pressure sensor faulty medium
  • Signal shorted to 5 V or battery voltage low
  • Engine module low

Symptoms

  • Check engine light on
  • EVAP readiness not set, emission inspection not passed
  • No change in driving

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P0453

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication