P0452
EVAP System Pressure Sensor/Switch A Circuit Low
The evaporative emission (EVAP) system stores fuel vapour from the tank in a charcoal canister; a purge valve lets the engine draw it off, and a vent valve opens the canister to fresh air. The tank pressure sensor measures small pressures around ambient for the leak tests. Its direction differs by maker – on GM vacuum raises the voltage, on Ford and Bosch pressure does – so low and high refer to the signal voltage only. P0452 means its signal voltage is below the lower limit: GM below 0.15 V (640 of 800 samples, MIL after two trips), Ford below 0.1 V for 5 s, Saab below 0.1 V for more than 5 s. Common causes are a signal wire shorted to ground, an interrupted or shorted 5 V reference or a faulty sensor. Leak and purge tests are then suspended.
Possible causes
- Signal wire shorted to ground or connector corroded high
- Tank pressure sensor faulty internally medium
- 5 V reference open or shorted (shared reference) medium
- Engine module low
Symptoms
- Check engine light on
- EVAP readiness not set, emission inspection not passed
- No change in driving
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P0452
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.
Sources
- gsi.ext.gm.com/gmspo/mode6/pdf/2018/18OBDG03A Engine Diagnostics.pdf
- newtonnet.co.uk/fiesta/fordobd2012.pdf
- saabwisonline.com/9-4x/2011/2-engine/engine-management-and-fuel-system-v6/fault-diagnosis-diagnostic-trouble-codes/dtc-p0451-p0454-lf1-lfw
- saabwisonline.com/9-3-9440/2006/dtcs/me9/p0452-00
- saabwisonline.com/900/1998/2-engine/evaporative-emission-system-orvr-obd-ii/fault-diagnosis-diagnostic-trouble-codes/p0452