OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0450

EVAP System Pressure Sensor/Switch A Circuit

The evaporative emission (EVAP) system stores fuel vapour from the tank in a charcoal canister; a purge valve lets the engine draw it off, and a vent valve opens the canister to fresh air. The tank pressure sensor measures small pressures around ambient for the leak tests. Its direction differs by maker – on GM vacuum raises the voltage, on Ford and Bosch pressure does – so low and high refer to the signal voltage only. P0450 is the general circuit fault of tank pressure sensor A; makers that separate the fault use P0452 or P0453. Only Audi (2022/23) is documented with the code, as an electrical fault of the tank ventilation pressure sensor; GM, Ford and Saab do not use it. The leak tests are then suspended.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number4 / 50

Possible causes

  • Connector at the tank pressure sensor corroded or loose (underbody, splash water) high
  • Tank pressure sensor faulty medium
  • Damaged 5 V, ground or signal wire medium
  • Engine module software low

Symptoms

  • Check engine light on
  • EVAP readiness not set, emission inspection not passed
  • No change in driving

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P0450

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication