P0449
EVAP System Vent Valve Control Circuit/Open
The evaporative emission (EVAP) system stores fuel vapour from the tank in a charcoal canister; a purge valve lets the engine draw it off, and a vent valve opens the canister to fresh air. P0449 belongs to the newer scheme for the vent valve circuit – P0449 open, P0498 low, P0499 high – used mainly by GM and also by VW. The normally open valve is fed from the battery and switched to ground; with the driver off, the output should show supply voltage. A floating 2.6–4.6 V, or an impedance of 200 kΩ or more, means an open circuit (GM: 20 of 25 samples, MIL after two trips). The leak test and the vent performance check P0446 are then suspended; purging continues.
Possible causes
- Vent valve connector (usually at the canister or tank, underbody) corroded or loose high
- Vent valve coil open medium
- Supply (fuse) or control wire open medium
- Driver in the engine module low
Symptoms
- Check engine light on
- EVAP leak test does not run, readiness not set
- Usually no change in driving
Inspection / repair
- Difficulty: easy
- DIY: possible
What Pro shows you for P0449
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.
Sources
- gsi.ext.gm.com/gmspo/mode6/pdf/2018/18OBDG03A Engine Diagnostics.pdf
- saabwisonline.com/9-4x/2011/2-engine/engine-management-and-fuel-system-v6/fault-diagnosis-diagnostic-trouble-codes/dtc-p0449-p0498-or-p0499-lau
- gsi.ext.gm.com/gmspo/mode6/pdf/2006/2006file4.pdf
- static.nhtsa.gov/odi/tsbs/2013/SB-10053936-1988.pdf