P0444
EVAP System Purge Control Valve A Circuit Open
The evaporative emission (EVAP) system stores fuel vapour from the tank in a charcoal canister; a purge valve lets the engine draw it off, and a vent valve opens the canister to fresh air. P0444 belongs to the older scheme of circuit, open and shorted codes for purge valve A; Saab's Trionic T7 and VW use it, while GM reports an open circuit as P0443 and Ford covers everything in P0443. Saab checks with the output switched off: below 2 V the supply through the coil is missing or the line is grounded – Saab combines both under P0444, sets it after about 1 s and pauses the check until the next drive. Purging then stops.
Possible causes
- Purge valve connector off or corroded high
- Valve coil open medium
- Supply wire, fuse, main relay or control wire open medium
- Control wire shorted to ground (Saab definition) low
Symptoms
- Check engine light on
- Possibly fuel smell
- EVAP monitors do not run
Inspection / repair
- Difficulty: easy
- DIY: possible
What Pro shows you for P0444
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.