P0443
EVAP System Purge Control Valve A Circuit
The evaporative emission (EVAP) system stores fuel vapour from the tank in a charcoal canister; a purge valve lets the engine draw it off, and a vent valve opens the canister to fresh air. P0443 is the electrical check of purge valve A, which the module switches to ground in pulses; it compares the driver's feedback voltage with the commanded state. GM uses it for an open circuit (200 kΩ or more, 20 of 25 samples, MIL after two trips) and reports shorts as P0458/P0459; Ford covers open and short in P0443 (5 s). Purging then stops, the canister is no longer regenerated, and the leak and purge monitors are suspended.
Possible causes
- Purge valve connector corroded, loose or off high
- Purge valve coil open or shorted medium
- Control wire broken or chafed, or supply missing (fuse, main relay) medium
- Driver in the engine module low
Symptoms
- Check engine light on
- Possibly fuel smell (no purging)
- EVAP leak test does not run
Inspection / repair
- Difficulty: easy
- DIY: possible
What Pro shows you for P0443
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.
Sources
- gsi.ext.gm.com/gmspo/mode6/pdf/2018/18OBDG03A Engine Diagnostics.pdf
- gsi.ext.gm.com/gmspo/mode6/pdf/2006/2006file4.pdf
- fordservicecontent.com/Ford_Content/catalog/motorcraft/OBD-Operations-Summary-Gasoline-2020-2023.pdf
- saabwisonline.com/9-4x/2011/2-engine/engine-management-and-fuel-system-v6/fault-diagnosis-diagnostic-trouble-codes/dtc-p0443-or-p0449-lf1-lfw