OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P043F

EVAP System Leak Detection Reference Orifice High Flow

The evaporative emission (EVAP) system stores fuel vapour from the tank in a charcoal canister; a purge valve lets the engine draw it off, and a vent valve opens the canister to fresh air. Systems with a leak detection pump (Bosch DM-TL at VW, Audi, BMW and Maserati, Denso's canister pump module at Toyota/Lexus) first measure a reference value with the pump working only through a built-in 0.5 mm (0.020 in) orifice; it is the yardstick for the small-leak test that CARB requires. P043F means the reference measurement shows too much flow – the reference vacuum or pressure does not reach the expected value, because the reference path or changeover valve leaks, the pump is weak, or air enters through leaking valves in the test path. The leak test can then not be judged, since a weak yardstick would hide leaks. GM and Ford do not use the code.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number4 / 3F

Possible causes

  • Leak detection pump faulty (weak pump, leaking changeover valve, liquid damage) high
  • Purge valve does not seal medium
  • Pump supply or connector (contact resistance, corrosion) medium
  • Leaking hose between pump module and canister low

Symptoms

  • Check engine light on
  • EVAP leak test does not run, readiness not set
  • Usually no change in driving

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P043F

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication