OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P043D

Catalyst Temperature Sensor Circuit High Bank 2 Sensor 2

Some engines – mainly diesels – measure the temperature at or in the catalyst with a thermistor in a voltage divider instead of only modelling it; most makers report exhaust temperature sensors under P0544 ff, P2031 ff or P2080 ff instead. Sensor 2 of bank 2 is a second, further downstream catalyst temperature sensor on the side without cylinder 1. P043D means the signal voltage is above its upper limit – typically the sensor or its wiring is open, or the signal is shorted to positive. No manufacturer document available to us uses this code; the description follows CARB, which requires input circuits to be checked for circuit faults and plausibility, and the comparable exhaust temperature sensors.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number4 / 3D

Possible causes

  • Sensor or wire open (broken by vibration or heat) high
  • Connector off or loose, ground wire open high
  • Signal wire shorted to positive low
  • Engine module low

Symptoms

  • Check engine light on
  • Usually no noticeable change (substitute value from the model)
  • Diesel: filter regeneration distorted or blocked, possibly further codes such as P2459 or P0420

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P043D

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication