P0439
Catalyst Heater Control Circuit/Open (Bank 2)
The drive circuit for the heated catalyst on bank 2 is open. Heated catalysts use an electrical heating element to reach light-off temperature within seconds of cold start.
Possible causes
- Heater element or wiring open high
- Pin pushed back out of connector body low
- Cracked solder joint inside the module or sensor low
Symptoms
- Check engine light on
- Failed emissions inspection
- Possibly slightly increased fuel consumption
- Sulfur (rotten egg) smell from exhaust under load
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
Pro mode: costs, time and components
Free with the newsletter by Fabian Brose: enter your name and email, confirm by mail – Pro mode is then unlocked on this device for 30 days. The newsletter arrives about every two weeks, unsubscribe at any time. Already subscribed? One click is enough – you will be recognised.
Unlock Pro mode for free