P0433
Heated Catalyst Efficiency Below Threshold Bank 2
An electrically heated catalyst has a heating disc ahead of a support catalyst so that it works soon after a cold start (Emitec EMICAT, 12–48 V); it was tried on Californian petrol cars in the 1990s and is used today mainly on diesels, for example Audi's 3.0 TDI from 2014 and 48-volt diesel vans. P0433 means the heated catalyst of bank 2 (the side without cylinder 1) no longer converts enough; CARB requires it to be assessed like any other catalyst. No manufacturer document available to us uses this code.
Possible causes
- Heated catalyst aged or poisoned high
- Heater not working, catalyst active too late medium
- Sensor used for the assessment faulty medium
- Calibration (Ram: software update per bulletin) medium
Symptoms
- Check engine light on
- Higher emissions after a cold start
- Otherwise usually unremarkable
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P0433
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.