P0427
Catalyst Temperature Sensor Circuit Low Bank 1 Sensor 1
Some engines – mainly diesels – measure the temperature at or in the catalyst with a thermistor in a voltage divider instead of only modelling it; most makers report exhaust temperature sensors under P0544 ff, P2031 ff or P2080 ff instead. Sensor 1 of bank 1 is the first catalyst temperature sensor on the side with cylinder 1. P0427 means the signal voltage is below its lower limit – typically the signal wire is shorted to ground or the sensor is shorted internally. FCA's 3.0-litre EcoDiesel uses this sensor (middle of the oxidation catalyst and particulate filter unit), but no document available to us names this particular code.
Possible causes
- Signal wire shorted to ground (chafed) high
- Sensor shorted internally medium
- Water or corrosion in the connector medium
- Engine module low
Symptoms
- Check engine light on
- Usually no noticeable change (substitute value from the model)
- Diesel: filter regeneration distorted or blocked, possibly further codes such as P2459 or P0420
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P0427
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.