OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0412

AIR System Switching Valve A Circuit

The switching valve is the electrically driven valve of this path – a solenoid valve, or on Pierburg/VW systems an electric changeover valve that applies vacuum to the pneumatic combination valve; valve A serves the first path or bank 1, valve B the second. P0412 is the general electrical fault in the control circuit of valve A, detected by comparing the driver's feedback with its commanded state. GM has used it since about 2015 specifically for an open circuit (200 kΩ or more, 20 of 25 samples, MIL after two trips) and reports shorts as P041F and P044F; older GM systems and Toyota use it for any driver fault. The valve then stays shut, so secondary air is missing and P0411 or P2441 may follow.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number4 / 12

Possible causes

  • Switching valve A faulty (coil open or shorted, water ingress) high
  • Connector corroded or wire open or chafed high
  • Valve supply missing (fuse, main relay) medium
  • Driver in the engine module low

Symptoms

  • Check engine light on
  • Secondary air inactive
  • Secondary air readiness not set (emission test)
  • Driving normal

Inspection / repair

  • Difficulty: easy
  • DIY: possible

What Pro shows you for P0412

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication