P0406
EGR Sensor A Circuit High
Exhaust gas recirculation (EGR) routes part of the exhaust back into the intake to lower combustion temperature and NOx. EGR sensor A is usually the valve position sensor; on Ford until about 2011 the DPFE differential pressure sensor. P0406 means its signal is above the upper limit – GM 2018 above 97.7 % of 5 V, GM 2005 above 94.7 % (both MIL after two trips), Ford petrol above 95 % for 4 s, Ford diesel above 4.70 V, Saab above 4.75 V. Typical is a signal wire shorted to positive or an open sensor ground, which GM names explicitly. EGR is then switched off.
Possible causes
- Sensor ground or return wire open high
- Signal wire shorted to 5 V or positive medium
- Sensor in the EGR valve faulty medium
- Moisture or corrosion in the connector medium
Symptoms
- Check engine light on
- EGR switched off
- Diesel: possibly reduced power
- Otherwise hardly noticeable
Inspection / repair
- Difficulty: easy
- DIY: possible
What Pro shows you for P0406
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 4 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.
Sources
- gsi.ext.gm.com/gmspo/mode6/pdf/2018/18OBDG04 Engine Diagnostics.pdf
- gsi.ext.gm.com/gmspo/mode6/pdf/2005/2005file4.pdf
- fordservicecontent.com/Ford_Content/catalog/motorcraft/obd-summary-diesel-2023.pdf
- saabwisonline.com/9-5-9650/2010/2-engine/engine-management-and-fuel-system-4-cyl-diesel/fault-diagnosis-diagnostic-trouble-codes/dtc-p0405-or-p0406