P0403
EGR A Control Circuit/Open
Exhaust gas recirculation (EGR) routes part of the exhaust back into the intake to lower combustion temperature and NOx. P0403 concerns the electrical drive of the EGR valve – solenoid, stepper motor, DC motor or vacuum regulator. The module checks the output and sets the code for an open circuit (GM: above 200 kΩ, MIL after two trips; Ford after 4 s, MIL after two trips). Newer systems report shorts separately as P0489 (low) and P0490 (high); Ford and older GM systems include them in P0403. EGR is then switched off for the rest of the trip.
Possible causes
- Connector at the EGR valve corroded or loose high
- Broken control or supply wire medium
- Coil or motor in the EGR valve burnt out medium
- Driver in the engine module low
Symptoms
- Check engine light on
- EGR switched off: pinging (petrol) or higher NOx
- Usually no loss of power
Inspection / repair
- Difficulty: easy
- DIY: possible
What Pro shows you for P0403
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 4 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.
Sources
- gsi.ext.gm.com/gmspo/mode6/pdf/2018/18OBDG04 Engine Diagnostics.pdf
- newtonnet.co.uk/fiesta/fordobd2012.pdf
- saabwisonline.com/9-5-9650/2010/2-engine/engine-management-and-fuel-system-4-cyl-diesel/fault-diagnosis-diagnostic-trouble-codes/dtc-p0403-p0489-or-p0490
- gsi.ext.gm.com/gmspo/mode6/pdf/2004/2004file4.pdf