P03FD
Ignition L Control Signal Circuit/Open
Ignition L is one of up to twelve control signal lines (A to L) from the engine module to an ignition coil with integrated output stage or to an ignition module – plausibly the 12th channel, but the code standard leaves the assignment to the manufacturer. The code concerns this logic-level signal, not the coil's primary circuit (coil L has its own codes, P0362 and P2333 ff). P03FD means the control line is open or high-resistance: with its driver switched off the module sees a voltage that indicates a missing load (GM uses more than 30 kΩ for comparable coil drivers). The coil fires wrongly or not at all; the misfire usually also sets P0300 ff, and many modules shut off injection to that cylinder to protect the catalyst. No manufacturer document available to us uses this code – it would only concern twelve-cylinder engines, whose makers publish no OBD summaries; GM and Ford tables stop at eight and ten cylinders.
Possible causes
- Control line or connector pin open (corrosion, pushed-back pin) high
- Coil with integrated output stage or ignition module faulty medium
- Supply or ground of the coil or module missing medium
- Driver in the engine module low
Symptoms
- Check engine light on, may flash with severe misfire
- Misfire on the cylinder of this channel, rough running
- Loss of power, cylinder possibly shut off
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P03FD
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 4 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.