P03FB
Ignition K Control Signal Circuit Low
Ignition K is one of up to twelve control signal lines (A to L) from the engine module to an ignition coil with integrated output stage or to an ignition module – plausibly the 11th channel, but the code standard leaves the assignment to the manufacturer. The code concerns this logic-level signal, not the coil's primary circuit (coil K has its own codes, P0361 and P2330 ff). P03FB means the signal stays too low – typically the control line is shorted to ground or the input of the output stage is shorted, so the driver never sees a high level. The coil fires wrongly or not at all; the misfire usually also sets P0300 ff, and many modules shut off injection to that cylinder to protect the catalyst. No manufacturer document available to us uses this code – it would only concern twelve-cylinder engines, whose makers publish no OBD summaries; GM and Ford tables stop at eight and ten cylinders.
Possible causes
- Control line shorted to ground (chafed harness) high
- Input of the coil output stage shorted medium
- Moisture or corrosion in the connector medium
- Driver in the engine module low
Symptoms
- Check engine light on, may flash with severe misfire
- Misfire on the cylinder of this channel, rough running
- Loss of power, cylinder possibly shut off
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P03FB
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 4 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.