OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P03FA

Ignition K Control Signal Circuit/Open

Ignition K is one of up to twelve control signal lines (A to L) from the engine module to an ignition coil with integrated output stage or to an ignition module – plausibly the 11th channel, but the code standard leaves the assignment to the manufacturer. The code concerns this logic-level signal, not the coil's primary circuit (coil K has its own codes, P0361 and P2330 ff). P03FA means the control line is open or high-resistance: with its driver switched off the module sees a voltage that indicates a missing load (GM uses more than 30 kΩ for comparable coil drivers). The coil fires wrongly or not at all; the misfire usually also sets P0300 ff, and many modules shut off injection to that cylinder to protect the catalyst. No manufacturer document available to us uses this code – it would only concern twelve-cylinder engines, whose makers publish no OBD summaries; GM and Ford tables stop at eight and ten cylinders.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number3 / FA

Possible causes

  • Control line or connector pin open (corrosion, pushed-back pin) high
  • Coil with integrated output stage or ignition module faulty medium
  • Supply or ground of the coil or module missing medium
  • Driver in the engine module low

Symptoms

  • Check engine light on, may flash with severe misfire
  • Misfire on the cylinder of this channel, rough running
  • Loss of power, cylinder possibly shut off

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P03FA

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication