P03F9
B Camshaft Position Actuator Position Sensor C Circuit High Bank 1
On some engines the exhaust cam phaser (camshaft position actuator B) has its own position sensors, which tell the engine module where the phaser actually is; sensor C is the third of them, bank 1 the side with cylinder 1. This is a different family from the sliding-cam position sensors (P2C05 ff). P03F9 means the signal stays above its upper limit – typically an open sensor ground, a signal wire shorted to 5 V or battery voltage, or a faulty sensor. No manufacturer document available to us uses this code (GM, Ford and FCA tables checked); the intake counterpart P03E5 ff is equally unused. The phaser is then usually held in its base position.
Possible causes
- Sensor ground open or signal wire shorted to 5 V or battery voltage high
- Sensor faulty medium
- Connector wet or corroded medium
- Engine module low
Symptoms
- Check engine light on
- Exhaust cam phasing held in its base position, loss of power
- Possibly rough idle or poorer emissions
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P03F9
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 4 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.