OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P03F6

B Camshaft Position Actuator Position Sensor C Circuit Bank 1

On some engines the exhaust cam phaser (camshaft position actuator B) has its own position sensors, which tell the engine module where the phaser actually is; sensor C is the third of them, bank 1 the side with cylinder 1. This is a different family from the sliding-cam position sensors (P2C05 ff). P03F6 is the general circuit code for this sensor: the module sees an open circuit or a signal outside its valid window on the supply, signal or ground line. No manufacturer document available to us uses this code (GM, Ford and FCA tables checked); the intake counterpart P03E5 ff is equally unused. The phaser is then usually held in its base position.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number3 / F6

Possible causes

  • Connector or harness to position sensor C open or corroded high
  • Position sensor C faulty medium
  • 5 V reference or ground disturbed medium
  • Engine module low

Symptoms

  • Check engine light on
  • Exhaust cam phasing held in its base position, loss of power
  • Possibly rough idle or poorer emissions

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P03F6

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication