OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P03F5

B Camshaft Profile Actuator C Control Stuck On Bank 1

With a sliding camshaft, the exhaust camshaft (camshaft B) carries movable cam pieces with several lift profiles; solenoid actuators shoot a pin into a groove in the piece and shift it axially. Actuator C is the third of these actuators – not a profile position. The only known user is GM's 2.7-litre turbo four (L3B, three-step sliding cam, from model year 2019). P03F5 means the actuator stays on: its pin remains extended although it was commanded off. No manufacturer document available to us uses this code – GM monitors its exhaust actuators only for circuit faults and uncommanded extension; the description follows the intake counterpart P03F0, where GM sets the code if the pin does not retract by the end of the engine cycle.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number3 / F5

Possible causes

  • Pin sticking in the actuator (sludge, wear) high
  • Return ramp of the shift groove damaged or cam piece sticking medium
  • Solenoid stays energized (control wire shorted to ground) medium
  • Hall feedback faulty low

Symptoms

  • Check engine light on
  • Ticking or rattling at the camshaft carrier
  • Misfire, rough idle or less power in the wrong lift profile
  • Lift switching and cylinder deactivation out of service

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P03F5

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication