P03F4
B Camshaft Profile Actuator C Control Performance/Stuck Off Bank 1
With a sliding camshaft, the exhaust camshaft (camshaft B) carries movable cam pieces with several lift profiles; solenoid actuators shoot a pin into a groove in the piece and shift it axially. Actuator C is the third of these actuators – not a profile position. The only known user is GM's 2.7-litre turbo four (L3B, three-step sliding cam, from model year 2019). P03F4 is the function check: in the standard's wording the actuator does not do what is commanded. A Hall sensor in the actuator reports the pin position. GM uses this code for a pin that extends without being commanded (4 of 5 cylinder events, MIL on the first trip); a pin that does not extend on command shows up there through the cam piece position sensors (GM-specific codes P30BE ff). GM bulletins name swapped actuator connectors and actuators fitted to the wrong camshaft after repairs.
Possible causes
- Actuator faulty inside: pin extends uncommanded (weak return spring) high
- Actuator connectors swapped, or intake and exhaust actuators fitted to the wrong camshaft medium
- Interference in the Hall feedback signal (ground, connector) medium
- Cam piece sticking or shift groove worn low
Symptoms
- Check engine light on
- Ticking or rattling at the camshaft carrier
- Misfire, rough idle or less power in the wrong lift profile
- Lift switching and cylinder deactivation out of service
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P03F4
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 4 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.