OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P03EB

A Camshaft Profile Actuator Position Sensor C Exceeded Learning Limit

Engines with cam profile switching move the intake camshaft between lift profiles with actuators – for example pins that shift a sliding cam – and position sensors report which profile is engaged. The engine module learns reference values of position sensor C, such as its end-position levels or the expected pulse position relative to the crankshaft and camshaft sensors; a Ford patent describes correcting this position for the cam phase. P03EB means the learned value lies outside the permitted adaptation limit, so profile detection is no longer reliable and the module usually stays in a safe profile. No manufacturer document available to us describes the code or its limits; GM's 2.7-litre sliding cam has no learning-limit code. CARB lists a pin that does not reach its position among the faults to be detected.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number3 / EB

Possible causes

  • Position sensor C or actuator with integrated sensor worn or faulty (signal drift) high
  • Actuator pin or sliding piece stiff, guide worn, dirty oil medium
  • Actuator not relearned or wrongly fitted after replacement medium
  • Connector or wiring with contact resistance low
  • Engine module software (learning algorithm) low

Symptoms

  • Check engine light on
  • Profile switching disabled: less power at high revs or higher consumption
  • Possibly further profile actuator or sensor codes

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P03EB

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication