P03E8
A Camshaft Position Actuator Position Sensor C Circuit High Bank 1
On some engines the intake cam phaser (camshaft position actuator A) has its own position sensors, which tell the engine module where the phaser actually is; sensor C is the third of them, bank 1 the side with cylinder 1. P03E8 means the sensor signal stays above its upper limit – typically an open sensor ground, a signal wire shorted to 5 V or battery voltage, or a faulty sensor. No manufacturer document available to us uses this code. GM's 2.7-litre engine monitors comparable position sensors on its sliding camshaft under other codes (P2C05 ff), with an open circuit above 200 kΩ and a short below 0.5 Ω in 4 of 5 samples – only as a comparison. The phaser is then usually held in its base position, with a loss of power.
Possible causes
- Sensor ground open or connector corroded high
- Signal wire shorted to 5 V or vehicle voltage medium
- Sensor faulty medium
- Engine module low
Symptoms
- Check engine light on
- Cam phasing held in its base position, loss of power
- Possibly rough idle or higher consumption
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P03E8
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 4 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.