OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P03E7

A Camshaft Position Actuator Position Sensor C Circuit Low Bank 1

On some engines the intake cam phaser (camshaft position actuator A) has its own position sensors, which tell the engine module where the phaser actually is; sensor C is the third of them, bank 1 the side with cylinder 1. P03E7 means the sensor signal stays below its lower limit – signal or reference wire shorted to ground, supply open, or the sensor shorted internally; if the 5 V reference is the cause, other sensors on the same circuit often set codes too. No manufacturer document available to us uses this code. GM's 2.7-litre engine monitors comparable position sensors on its sliding camshaft under other codes (P2C05 ff), with an open circuit above 200 kΩ and a short below 0.5 Ω in 4 of 5 samples – only as a comparison. The phaser is then usually held in its base position.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number3 / E7

Possible causes

  • Signal wire shorted to ground (chafed harness) high
  • 5 V supply open or shorted medium
  • Sensor faulty internally medium
  • Engine module low

Symptoms

  • Check engine light on
  • Cam phasing held in its base position, loss of power
  • Possibly rough idle or higher consumption

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P03E7

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication