P03E6
A Camshaft Position Actuator Position Sensor C Range/Performance Bank 1
On some engines the intake cam phaser (camshaft position actuator A) has its own position sensors, which tell the engine module where the phaser actually is; sensor C is the third of them, bank 1 the side with cylinder 1. P03E6 means the sensor signal is electrically valid but implausible – for example the number or position of its edges per engine cycle does not match the crankshaft sensor, it jumps, or it lies outside the phaser's adjustment range. No manufacturer document available to us uses this code. GM's 2.7-litre engine monitors comparable position sensors on its sliding camshaft under other codes (P2C05 ff), with an open circuit above 200 kΩ and a short below 0.5 Ω in 4 of 5 samples – only as a comparison. Typical causes are a dirty sensor or wrong air gap, a damaged or wrongly fitted phaser, or interference.
Possible causes
- Sensor dirty (metal debris on the magnet) or air gap wrong high
- Phaser or sensor target damaged or wrongly fitted (timing) medium
- Loose contact or interference medium
- Sensor faulty medium
Symptoms
- Check engine light on
- Cam phasing held in its base position, loss of power
- Possibly rough idle or higher consumption
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P03E6
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 4 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.