OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P03E1

Cylinder 8 Pressure Too High

Some diesels have a combustion pressure sensor in the glow plug; the engine module uses it to control injection for each cylinder. This code concerns cylinder 8. P03E1 means the pressure measured or calculated for the cylinder is higher than expected. The 'pressure too high' codes are documented only at Audi, for cylinders 1 to 4 of the 2015 S3 petrol engine, where a software fault mis-detected misfire. On diesels with pressure-sensing glow plugs GM patents describe a peak pressure above its limit – too much or too early injection, or a sensor drifting upwards. For cylinder 8, which only engines with at least 8 cylinders have, no manufacturer document available to us uses the code; the description follows that logic and CARB. If the cylinder is shut off, power drops noticeably.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number3 / E1

Possible causes

  • Injector delivering too much or dripping medium
  • Sensor drifting upwards (diesel pressure-sensing glow plug) medium
  • Knock or pre-ignition on a petrol engine low

Symptoms

  • EPC or check engine light on
  • Misfire codes, possibly a cylinder shut off with noticeable loss of power
  • Rough running

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P03E1

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication