P03D1
Cylinder 7 Pressure Sensor Circuit
Some diesels have a combustion pressure sensor in the glow plug; the engine module uses it to control injection for each cylinder. This code concerns cylinder 7. P03D1 is the general circuit code for this pressure sensor, meant for modules that do not separate open circuits and shorts into low and high. The only manufacturer we found using this code family, GM's European 2.0 CDTI four-cylinder diesel (Saab 9-5), splits such faults into low and high codes for cylinders 1 to 4, and VW's US 2.0 TDI engines with pressure-sensing glow plugs use their own codes (P13CE ff). For cylinder 7, which only engines with at least 7 cylinders have, no manufacturer document available to us uses the code; the description follows that logic and CARB. The sensor has three wires (5 V reference, ground, signal); without it the module drops combustion control for that cylinder.
Possible causes
- Connector at the pressure-sensing glow plug loose or corroded high
- Reference, signal or ground wire open or shorted medium
- Sensor electronics in the glow plug faulty medium
- Engine module (reference voltage or input) low
Symptoms
- Check engine light on (often after two trips)
- Usually barely noticeable – combustion control for the cylinder is switched off
- Possibly rougher running, more noise or slightly higher consumption
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P03D1
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.