P03CD
Cylinder 6 Pressure Too High
Some diesels have a combustion pressure sensor in the glow plug; the engine module uses it to control injection for each cylinder. This code concerns cylinder 6. P03CD means the pressure measured or calculated for the cylinder is higher than expected. The 'pressure too high' codes are documented only at Audi, for cylinders 1 to 4 of the 2015 S3 petrol engine, where a software fault mis-detected misfire. On diesels with pressure-sensing glow plugs GM patents describe a peak pressure above its limit – too much or too early injection, or a sensor drifting upwards. For cylinder 6, which only engines with at least 6 cylinders have, no manufacturer document available to us uses the code; the description follows that logic and CARB. If the cylinder is shut off, power drops noticeably.
Possible causes
- Injector delivering too much or dripping medium
- Sensor drifting upwards (diesel pressure-sensing glow plug) medium
- Knock or pre-ignition on a petrol engine low
Symptoms
- EPC or check engine light on
- Misfire codes, possibly a cylinder shut off with noticeable loss of power
- Rough running
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P03CD
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 4 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.