Powertrain
generic / SAE
P03CB
Cylinder 6 Pressure Sensor Circuit Intermittent/Erratic
Cylinder 6 pressure sensor signal jumps or drops out intermittently — connector or wiring issue. Wiring faults of this kind typically come from chafing, water ingress at connector seals, or pin push-back — a wiggle test on the harness while the code is active often confirms the location.
SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number3 / CB
Possible causes
- Intermittent connector high
- Connector with intermittent contact under vibration low
- Harness routed against vibrating component low
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
- Estimated cost: 150–1200 €
- Estimated time: 1–4 h
- Component: cylinder pressure sensor
- MIL / check engine light
- emissions-relevant
Sources
References
sae:J2012