P03C1
Cylinder 5 Pressure Sensor Circuit Intermittent/Erratic
Some diesels have a combustion pressure sensor in the glow plug; the engine module uses it to control injection for each cylinder. This code concerns cylinder 5. P03C1 means the sensor signal is erratic or drops out for moments – typically a loose contact at the glow plug connector, a chafed harness or sensor electronics unstable with temperature. The only manufacturer we found using this code family, GM's European 2.0 CDTI four-cylinder diesel (Saab 9-5, 2010), uses it for cylinders 1 to 4 as 'circuit erratic': signal outside its range for more than 0.2 s with the engine running. For cylinder 5, which only engines with at least 5 cylinders have, no manufacturer document available to us uses the code; the description follows that logic and CARB. The code often comes and goes.
Possible causes
- Loose contact at the glow plug connector high
- Chafing or broken wire in the engine harness medium
- Sensor electronics of the glow plug unstable with temperature medium
- Interference from ground problems low
Symptoms
- Check engine light on
- Occasionally rough running
- Often no symptoms, the code comes and goes
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P03C1
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.
Sources
- law.cornell.edu/regulations/california/13-CCR-1968.2
- saabwisonline.com/9-5-9650/2010/2-engine/engine-management-and-fuel-system-4-cyl-diesel/fault-diagnosis-diagnostic-trouble-codes/dtc-p0399-p039c-p039d-p03a3-p03a6-p03a7-p03ad-p03b0-p03b1-p03b7-p03ba-or-p03bb
- borgwarner.com/aftermarket/diesel-cold-start-ignition/pressure-sensor-glow-plugs