OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P03BF

Cylinder 5 Pressure Sensor Circuit Low

Some diesels have a combustion pressure sensor in the glow plug; the engine module uses it to control injection for each cylinder. This code concerns cylinder 5. P03BF means the sensor signal stays below its lower limit – typically an open or grounded 5 V reference or a signal wire shorted to ground. The only manufacturer we found using this code family, GM's European 2.0 CDTI four-cylinder diesel (Saab 9-5, 2010), uses it for cylinders 1 to 4: signal below the threshold for more than 2 s with the engine running, check engine light after two trips, displayed pressure 0 kPa. For cylinder 5, which only engines with at least 5 cylinders have, no manufacturer document available to us uses the code; the description follows that logic and CARB. Without the signal, combustion control for this cylinder is switched off.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number3 / BF

Possible causes

  • 5 V reference wire open or shorted to ground high
  • Signal wire shorted to ground medium
  • Sensor electronics of the glow plug faulty medium
  • Engine module supplies no reference low

Symptoms

  • Check engine light on (often after two trips)
  • Usually barely noticeable – combustion control for the cylinder is switched off
  • Possibly rougher running, more noise or slightly higher consumption

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P03BF

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication