OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P03BA

Cylinder 4 Pressure Variation Low

Some diesels have a combustion pressure sensor in the glow plug; the engine module uses it to control injection for each cylinder. This code concerns cylinder 4. GM's European 2.0 CDTI diesel (Saab 9-5, 2010) uses P03BA as 'pressure variation too low', with three sub-checks, and sets it when the signal is outside its range for more than 0.2 s with the engine running; its fault table counts it among the signal performance faults together with the erratic code. What exactly is measured, Saab does not explain; presumably it is the swing of the pressure signal within an engine cycle – too small a swing means the signal barely responds, for example because the glow rod is stuck by carbon and no longer transmits the pressure, or because pressure build-up is missing. Usually there are no noticeable symptoms.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number3 / BA

Possible causes

  • Pressure-sensing glow plug faulty or coked (glow rod stuck) high
  • Contact resistance in connector or ground medium
  • Actual compression loss or misfire in the cylinder low

Symptoms

  • Check engine light on
  • Usually no noticeable symptoms
  • Possibly rough running or combustion noise because control is off

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P03BA

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication