OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P03B5

Cylinder 4 Pressure Sensor Circuit Low

Some diesels have a combustion pressure sensor in the glow plug; the engine module uses it to control injection for each cylinder. This code concerns cylinder 4. P03B5 means the sensor signal stays below its lower limit. GM's European 2.0 CDTI diesel (Saab 9-5, 2010) sets it when the signal is below the threshold for more than 2 s with the engine running, checked once per drive cycle, with the check engine light after two trips; the displayed maximum combustion pressure then reads 0 kPa instead of the normal 0–9,000 kPa. Saab names an open or grounded 5 V reference and a signal wire shorted to ground as causes; the glow plug should measure 3–12 Ω between reference and ground. Without the signal, combustion control for this cylinder is switched off, which is usually barely noticeable.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number3 / B5

Possible causes

  • 5 V reference wire open or shorted to ground high
  • Signal wire shorted to ground medium
  • Sensor electronics of the glow plug faulty medium
  • Engine module supplies no reference low

Symptoms

  • Check engine light on (often after two trips)
  • Usually barely noticeable – combustion control for the cylinder is switched off
  • Possibly rougher running, more noise or slightly higher consumption

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P03B5

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication