OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P03AE

Cylinder 3 Pressure Too Low

Some diesels have a combustion pressure sensor in the glow plug; the engine module uses it to control injection for each cylinder. This code concerns cylinder 3. P03AE means the pressure measured in the cylinder is lower than expected while the sensor itself is electrically fine. No manufacturer document available to us describes the code; GM patents show how such an evaluation works: peak and minimum pressure are compared with limits and with a motoring pressure calculated from manifold pressure and compression ratio, and the ratio of measured to motoring pressure is compared between cylinders. A low value can mean weak combustion or compression – leaking valve, worn rings, leaking glow plug seat, an injector delivering too little – or a sensor drifting downwards. The usual consequence is rough running and more smoke.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number3 / AE

Possible causes

  • Compression loss (valve, piston rings, leaking glow plug seat) medium
  • Injector delivering too little or coked medium
  • Sensor drifting downwards (deposits) medium
  • Misfire or partial combustion low

Symptoms

  • Check engine light on
  • Lack of power, rough running, possibly misfire on this cylinder
  • More smoke

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P03AE

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication