P03A6
Cylinder 2 Pressure Variation Low
Some diesels have a combustion pressure sensor in the glow plug; the engine module uses it to control injection for each cylinder. This code concerns cylinder 2. GM's European 2.0 CDTI diesel (Saab 9-5, 2010) uses P03A6 as 'pressure variation too low', with three sub-checks, and sets it when the signal is outside its range for more than 0.2 s with the engine running; its fault table counts it among the signal performance faults together with the erratic code. What exactly is measured, Saab does not explain; presumably it is the swing of the pressure signal within an engine cycle – too small a swing means the signal barely responds, for example because the glow rod is stuck by carbon and no longer transmits the pressure, or because pressure build-up is missing. Usually there are no noticeable symptoms.
Possible causes
- Pressure-sensing glow plug faulty or coked (glow rod stuck) high
- Contact resistance in connector or ground medium
- Actual compression loss or misfire in the cylinder low
Symptoms
- Check engine light on
- Usually no noticeable symptoms
- Possibly rough running or combustion noise because control is off
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P03A6
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.