OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0395

Cylinder 1 Pressure Sensor Circuit

Some diesels have a combustion pressure sensor in the glow plug; the engine module uses it to control injection for each cylinder. This code concerns cylinder 1. P0395 is the general circuit code for this pressure sensor, meant for modules that do not separate open circuits and shorts into low and high. The only manufacturer we found using this code family – GM's European 2.0 CDTI diesel, documented in Saab 9-5 workshop information – splits the faults into low and high (P0397, P0398) and does not use P0395; VW's US 2.0 TDI engines with pressure-sensing glow plugs report such faults with their own codes (P13CE ff). The description therefore follows CARB's requirement to monitor input sensors for circuit faults. The sensor has three wires (5 V reference, ground, signal); without it the module drops combustion control for that cylinder.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number3 / 95

Possible causes

  • Connector at the pressure-sensing glow plug loose or corroded high
  • Reference, signal or ground wire open or shorted medium
  • Sensor electronics in the glow plug faulty medium
  • Engine module (reference voltage or input) low

Symptoms

  • Check engine light on (often after two trips)
  • Usually barely noticeable – combustion control for the cylinder is switched off
  • Possibly rougher running, more noise or slightly higher consumption

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P0395

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication