P0394
Camshaft Position Sensor B Circuit Intermittent Bank 2
Camshaft position sensor B is the exhaust camshaft sensor; bank 2 is the side without cylinder 1, so the code only occurs on V and boxer engines with one exhaust cam sensor per bank. P0394 means the bank 2 exhaust cam signal now and then appears at a position where it is not expected relative to the crank reference – sporadic extra or missing edges. Ford checks this in its camshaft ignition system test from 200 rpm and decides within 5 s. FCA also uses the code and asks dealers to save the cam/crank synchronisation event data before replacing parts, a hint that the sensor itself is often not the culprit. GM does not use P0394 and reports such faults under P0391. Typical causes are a loose contact, interference or a damaged tone wheel.
Possible causes
- Loose contact or corrosion at the sensor connector or harness high
- Interference (ignition wiring, add-on devices, ground problems) medium
- Tone wheel or phaser damaged, or sensor loose medium
- Sensor faulty, temperature-dependent medium
Symptoms
- Check engine light on
- Sporadic jerking or stalling
- Occasionally longer cranking
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P0394
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 4 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.