OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0393

Camshaft Position Sensor B Circuit High Bank 2

Camshaft position sensor B is the exhaust camshaft sensor; bank 2 is the side without cylinder 1, so the code only occurs on V and boxer engines with one exhaust cam sensor per bank. P0393 means the bank 2 exhaust cam signal stays high without edges. Because the engine module pulls the Hall sensor's signal line up, an open wire leads to 'high' just like a short to positive – GM's 2004 3.6-litre V6 (LY7) therefore calls the fault 'circuit continuity or high' and counts it over two drive cycles. On the Saab 9-4X 2.8 turbo V6 (GM LAU) the signal must stay high without pulses for more than 1 s, or 10 s cumulatively, after two trips. Only manufacturers with separate low and high codes use it; newer GM petrol engines and Ford report the fault as P0390. The consequence is as for P0390: cam timing on bank 2 in its base position, loss of power, longer cranking.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number3 / 93

Possible causes

  • Signal wire open or connector off high
  • Sensor ground open medium
  • Signal wire shorted to positive medium
  • Sensor faulty medium

Symptoms

  • Check engine light on
  • Loss of power (bank 2 exhaust cam timing in its base position)
  • Longer cranking
  • Rough idle

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P0393

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication