OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0392

Camshaft Position Sensor B Circuit Low Bank 2

Camshaft position sensor B is the exhaust camshaft sensor; bank 2 is the side without cylinder 1, so the code only occurs on V and boxer engines with one exhaust cam sensor per bank. P0392 means the bank 2 exhaust cam signal stays low without edges – typically a short to ground of the signal wire, a sensor output stuck low or a missing 5 V reference. Only manufacturers with separate low and high codes use it: on the Saab 9-4X 2.8 turbo V6 (GM LAU) the signal must stay low without pulses for more than 1 s, or 10 s cumulatively, after more than 10 crank revolutions and below 2,520 rpm, after two trips; GM's 2004/2005 3.6-litre V6 (LY7, LP1) counts the fault over two drive cycles. Newer GM petrol engines (2015–2020) and Ford report the same fault as P0390. The consequence is as for P0390: cam timing on bank 2 in its base position, loss of power, longer cranking.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / number3 / 92

Possible causes

  • Signal wire shorted to ground high
  • Sensor faulty internally (output stuck low) medium
  • 5 V reference missing (shorted by another sensor on the same circuit) medium
  • Engine module low

Symptoms

  • Check engine light on
  • Loss of power (bank 2 exhaust cam timing in its base position)
  • Longer cranking
  • Rough idle

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P0392

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication